Kenwood KDC-BT6544U - Manual (Page 22)

22
| KDC-BT6544U/ KDC-BT6544UY/ KDC-BT6044/ KDC-BT6144/ KDC-W5544U/ KDC-W5644U
Audio Adjustments
Function of KDC-BT6044/BT6144/W5544U/W5644U
Speaker Setting
Fine-tuning so that the System Q value is optimal
when setting the speaker type as follows;
Speaker type Display
OFF “SP SEL OFF”
For 5 & 4 in. speaker “SP SEL 5/4”
For 6 & 6x9 in. speaker “SP SEL 6x9/6”
For the OEM speaker “SP SEL OEM”
1 Enter Standby
Press the [SRC] button.
Select the “STANDBY” display.
2 Enter Speaker Setting mode
Press the [AUD] knob.
3 Select the Speaker type
Turn the [AUD] knob.
4 Exit Speaker Setting mode
Press the [AUD] knob.
Function of KDC-BT6044/BT6144/W5544U/W5644U
Audio Preset Memory
Registering the value setup by Sound Control. The
memory cannot be erased by the Reset button.
1 Setup Sound Control
Refer to the following operations to setup the
Sound Control.
- <Audio Control> (page 20)
- <Audio Setup> (page 21)
2 Enter Audio Preset Memory mode (Other than
Standby mode)
Select “MENU”
> “AUDIO PRESET”.
Press the [AUD] knob for at least 1 second.
For how to select Function Control items, refer to
<Function Control> (page 6).
3 Select the Audio Preset Memory
Turn the [AUD] knob.
Select the “MEMORY” display.
4 Determine whether to put the Audio Preset in
the memory
Press the [AUD] knob.
Function of KDC-BT6044/BT6144/W5544U/W5644U
Audio Preset Recall
Recalling the sound setup registered by <Audio
Preset Memory> (page 22).
1 Select the source
2 Enter Audio Preset Recall mode (Other than
Standby mode)
Select “MENU”
> “AUDIO PRESET”.
Press the [AUD] knob for at least 1 second.
For how to select Function Control items, refer to
<Function Control> (page 6).
3 Select the Audio Preset Recall
Turn the [AUD] knob.
Select the “RECALL” display.
4 Determine whether to recall the Audio Preset
Press the [AUD] knob.
5 Recall the Audio Preset
Turn the [AUD] knob to select “YES”, and then
press the [AUD] knob.
“COMPLETE” is displayed.
6 Exit Audio Preset mode
Press the [SERACH] button twice.
⁄
• The User memory of “SYSTEM Q” in <Audio Control>
(page 20) is changed to the value which was recalled.
• The source tone memory item of <Audio Control> (page
20) is changed to the value which was recalled by the
selected source.
5 Put the Audio Preset in the memory
Turn the [AUD] knob to select “YES”, and then
press the [AUD] knob.
“COMPLETE” is displayed.
6 Exit Audio Preset mode
Press the [SERACH] button twice.
⁄
• Register 1 pair of Audio Preset Memory. You cannot
register by the source.
• When you press the Reset, all the sources will be the
setting value which is registered.
• The following items cannot be registered.
Volume, Balance, Fader, Volume offset, Dual Zone System,
Rear Volume
B64-4317-00_00_E_English.indd 22 08.11.1 3:47:59 PM