Kenwood KDC-5751SD - Manual (Page 31)

English |
31
Initial setting
Configures initial settings of this unit.
1
Select Standby
Press the [SRC] button.
Select the “STANDBY” display.
2
Enter Function setting mode
Press the Control knob for at least 1 second.
3
Select the Initial setting mode
Turn the Control knob to select “Initial Settings”,
and then press the Control knob.
4
Select the desired Initial setting item
Turn the Control knob to select Initial setting
item, and then press the Control knob.
Display Overview
“Initial Settings”
“Source Select” Select “2” to change the source selection
method. Press the [SRC] button, turn the
Control knob to select the source, and then
press the Control knob to determine it.
1 / 2
“Key Beep” Setting the operation check sound (beep
sound) ON/OFF.
“ON” / “OFF”
“Russian” When this is set to ON, the following character
strings are displayed in Russian:
Folder name/ File name/ Song title/ Artist
name/ Album name/ KCA-BT200/BT300
(optional accessory)
“ON” / “OFF”
“Function Language” Changes the display language of items in
Function setting.
“English” / “Français” / “Español” /
“Deutsch” / “Italiano” / “Pyccкий”
“Power OFF Wait” Setting the timer to turn this unit’s power OFF
automatically when Standby mode continues.
Using this setting can save the vehicle’s battery
power.
“OFF”: Power OFF Timer function is OFF.
“20MIN”: Turns the power OFF after 20
minutes. (Factory setting)
“40MIN”: Turns the power OFF after 40
minutes.
“60MIN”: Turns the power OFF after 60
minutes.
“Built-in AUX” Sets whether to display AUX during source
selection.
“ON” / “OFF”
“CD Read” Sets the method for reading CD.
When unable to play special format CD, set
this function to “2” to force playing. Note that
some music CDs may be unplayable even
when set to “2”.
In addition, audio files cannot be played when
set to “2”. Normally, keep this set to “1”.
1: Automatically distinguishes between audio
file disc and music CD when playing disc.
2: Forces playing as music CD.
“Built-in AMP” Selecting “OFF” turns off the built-in amplifier.
Turning off the built-in amplifier improves the
quality of the sound from Preout.
“ON” / “OFF”
“Speaker Select” Fine-tuning so that the System Q value is
optimal when setting the speaker type as
follows;
“OFF”: OFF
“5/4inch”: For 5 & 4 in. speaker
“6x9/6inch”: For 6 & 6x9 in. speaker
“O.E.M.”: For the OEM speaker
“F/W Update #.##” Upgrades the firmware.
Selecting “YES” and then pressing Control knob
starts upgrading the firmware.
For how to update the firmware, access our
web site.
http://www.kenwood.com/cs/ce/
( : Factory setting)
5
Set the Initial setting item
Turn the Control knob to select desired value,
and then press the Control knob.
The previous item is displayed.
6
Exit Function setting mode
Press the [ ] button for at least 1 second.