Teledex E Series - Manual (Page 12)

12 www.teledex.com E SERIES ANALOG USER GUIDE
When the handset is off-hook or the Speaker
key is engaged on the speakerphone, press the
volume control keys to increase or decrease the
volume. The handset volume control is an 8-step
operation. All models are hearing aid compatible.
RINGER VOLUME CONTROL
The ringer volume control switch is on the bottom
side of the phone.
The setting is either Low or HI (High).
INDICATORS
SPEAKER AND MUTE KEYS CONNECTING AND
STATUS INDICATORS
Speakerphones are equipped with LED indicators
to show the current feature key status.
• Press the Speaker or Mute key to use that
service—when in use the red LED lights up.
CALLING
PLACING A CALL USING THE HANDSET
• Lift the handset.
• Dial out by using the numeric dial pad or by
pressing a speed dial location.
RECEIVING A CALL USING THE HANDSET OR
SPEAKER
On a single-line telephone, when the phone rings,
lift the handset (or press the speaker key if you
have a speakerphone) to begin the conversation.
PLACING A CALL USING THE SPEAKERPHONE
The E Series speakerphones are equipped with
a high quality speakerphone feature to allow
hands-free operation. To use, simply press the
Speaker key when placing or answering a call.
The telephone line will activate automatically.
The Speaker key will light up indicating that the
speakerphone is in use. To hang up, press the
Speaker key again.
Programming
PROGRAM SPEED DIALS USING
SUBMERGED [STORE] AND [FLASH]
[Store] and [Flash] programming keys are located
under the faceplate and overlay. Access them by
lifting up the faceplate and overlay, using either a
paperclip or sharp pointer.
STORING A NUMBER INTO MEMORY
KEYS—[STORE]
Each speed-dial location can store up to 32 digits
in tone mode.
Note: Flash programmed into memory counts as
one digit when storing a number.
1. Lift the handset.
2. Press the STORE key.
3. Enter the number to be stored using the
numeric dial pad.
4. Press the desired memory location where
the number is to be stored.
5. If additional numbers are to be stored,
repeat steps 3 through 5.
6. Hang up the handset.
PROGRAMMING FLASH TIMING
Flash timing options are 100 ms through 1000
ms, programmable in 100 ms increments. The
default Flash timing is 600 ms.
1. Lift the handset.
2. Press the STORE Key once.
3. Program FLASH by pressing 1 for 100 ms,
2 for 200 ms, etc.
4. Press STORE.
5. Press FLASH.
6. Hang up phone to exit programming.
PROGRAMMING PAUSE TIMING
Pause timing options are 1 second through 5
seconds, programmable in 1 second increments.
The default pause timing is 3.5 seconds.
E100 AND E100TRM PHONES