Teledex E Series - Manual (Page 14)

Unpacking Your Telephone
This package should contain the following:
• Telephone base unit
• Mobile handset
• Paper faceplate
• Protective plastic overlay
• Power adapter (direct connect -7.5 300mA)
• Handset battery
• Two rubber plugs for the handset cover
• Two screws to secure the top and bottom
handset
Optional items to be ordered separately:
• Handset package: charging station, power
adapter, battery, handset, 2 rubber plugs, and
2 handset screws
Installation
CAUTION INFORMATION
• Never install telephone or network wiring
during a lightning storm.
• Never install telephone or Ethernet jacks
in wet locations unless the jack is specially
designed for wet locations.
• Never touch uninstalled telephone wires or
terminals unless the telephone line has been
disconnected at the network interface.
• Use caution when installing or modifying
telephone and network lines.
• Be sure your power adaptor meets your
regions requirements prior to installation.
CONNECTING THE POWER LINE CORD
Two line cords are provided: 1-RJ45 and 1-RJ11.
To install, simply plug one end of the RJ45 cord into
the modular jack at the top end of the base unit
and the other end into the RJ45 phone jack on the
power adaptor. Take the other RJ11 line cord and
plug into the line jack on the power adaptor, then
plug the other end into the wall. Finish by plugging
the power adaptor into a normal wall outlet.
Be sure your power adaptor is specified for your
region of the world prior to plugging it into the
wall socket.
HANDSET BATTERY
Charging the Handset Battery (On Base and
Charging Station):
The handset battery is a Ni-MH battery. This
battery requires a full charge prior to use to
ensure long life. To charge the battery, complete
the installation procedure by plugging the power
source into the wall outlet and the telephone
base or charging station.
Install the battery per instructions, inserting
battery plug into receptacle.
Place battery into opening in handset, press into
place, then replace cover and place handset into
base (face down) or charging station (face down).
BATTERY LIFE—WHEN COMPLETELY
CHARGED
• Talk time: 7.5 hours
• Standby (handset off-hook): 6 days
• Charge for 24 hours to ensure a fully-
charged battery
INSTALLING THE BATTERY INTO THE HANDSET
1. Hold the handset and gently push up the
handset back shell.
2. Slide the back shell, exposing the battery
compartment.
3. Install the battery plug into the receptacle,
matching up slot and opening on the
receptacle (do not force the battery).
4. Press battery into battery compartment
5. Slide the back shell of handset into slot,
then press down and snap into place.
6. Insert screws and gently tighten.
7. Insert rubber screw cover plugs.
14 www.teledex.com E SERIES ANALOG USER GUIDE
E103 AND E103 REDIDOCK PHONES