Teledex E Series - Manual (Page 25)

E SERIES ANALOG USER GUIDE www.teledex.com 25
be necessary to move the switch to either
LR1 or LR2. The correct position of the
switch will cause the message lamp to be
on continuously when a message is in the
mailbox.
PAGE
CALL THE HANDSET
Press the base unit’s Page key to call the handset
and the handset’s Message and On/Off indicator
lights flash. Press the Page key again (or any
key in the handset or place the handset into the
cradle) to end the page.
CONFERENCE
The CONF key allows for three-way conversations.
Depending on the situation, you may initiate a
conference call using one of these methods:
CASE A—USER INITIATES 2 CALLS
1. Place your call to the first party, then put
them on hold by pressing the HOLD key.
2. Using the second line (Line 2), place your
call to the second party, then put them on
hold by pressing the HOLD key.
3. Activate Conference by pressing the CONF
key to join the calls together.
CASE B—USER RECEIVES A CALL AND
PLACES A SECOND CALL
1. Receive a call from the first party, then put
them on hold by pressing the HOLD key.
2. Using the second line (Line 2), place a call
to the second party, then put them on hold
by pressing the HOLD key.
3. Activate Conference by pressing the CONF
key to join the calls together.
CASE C—USER RECEIVES A CALL AND THEN
RECEIVES A SECOND CALL
1. Receive a call from the first party, then
put them on hold by pressing the HOLD
key.
2. Using the second line (Line 2), place a call
to the second party, then put them on hold
by pressing the HOLD key.
3. Activate Conference by pressing the CONF
key to join the calls together.
TO TERMINATE A CONFERENCE CALL
Pressing a Line key will maintain the connection
with that line while dropping the other line. To
terminate the call entirely, place the handset
back in the cradle to go on-hook and disconnect
both parties.
REGISTERING A HANDSET
AUTO-SYNC REGISTRATION
Place the handset into the base unit cradle and
make sure the charging leads make contact. The
Line will light up, and the base and the handset
will enter Registration mode. When the base and
the handset have successfully paired, the phone
will beep a Registration confirmation tone.
SWITCH BETWEEN BASE AND
HANDSET
If the handset is registered with the base unit, then
the handset and base can switch the call freely.
To switch from the handset to the base, press the
Speaker key in the base unit. Press the ON/OFF
key in the handset to switch from base to handset.
SWITCH BETWEEN HANDSETS
Every base unit can register up to 4 additional
handsets. If one of the handsets is picking up, any
one of the other handsets can pick up the call by
E203 AND E203 REDIDOCK PHONES