Teledex E Series - Manual (Page 21)

E SERIES ANALOG USER GUIDE www.teledex.com 21
RECEIVING A CALL USING THE HANDSET OR
SPEAKER
On a two-line telephone, when the phone
rings select the ringing line (which will engage
the Speaker) or lift the handset to begin the
conversation.
PLACING A CALL USING THE SPEAKERPHONE
The E Series speakerphones are equipped with
a high-quality speakerphone feature to allow
hands-free operation. To use, simply press the
Speaker key when placing or answering a call.
The telephone line will activate automatically.
The Speaker key will light up indicating that the
speakerphone is in use. To hang up, press the
Speaker key again.
Programming
PROGRAM SPEED DIALS USING
SUBMERGED [STORE] AND [FLASH]
Store and Flash programming keys are located
under the faceplate and overlay. Lift up faceplate
and overlay by using either a paperclip or sharp
pointer.
STORING A NUMBER INTO MEMORY
KEYS—[STORE]
Each speed-dial location can store up to 32 digits
in tone mode.
Note: Flash programmed into memory counts as
one digit when storing a number.
1. Lift the handset.
2. Press the STORE key.
3. Enter the number to be stored using the
numeric dial pad.
4. Press the desired memory location
wherein the number is to be stored.
5. If additional numbers are to be stored,
repeat steps 3 through 5.
6. Hang up the handset.
PROGRAMMING FLASH TIMING
Flash timing options are 100 ms through 1000
ms, programmable in 100 ms increments. The
default Flash timing is 600 ms.
1. Lift the handset (off-hook position).
2. Press the STORE key once.
3. Program FLASH by pressing 1 for 100 ms,
2 for 200 ms, etc.
4. Press STORE.
5. Press FLASH.
6. Exit programming by hanging up the
handset.
PROGRAMMING PAUSE TIMING
Pause timing options are 1 second through 5
seconds, programmable in 1 second increments.
The default pause timing is 3.5 seconds.
1. Lift the handset (off-hook position).
2. Press the STORE key once.
3. Program PAUSE by pressing 1 for 1
second, 2 for 2 seconds, etc.
4. Press STORE.
5. Press PAUSE/REDIAL.
6. Exit programming by hanging up the
handset.
FLASH HOOK FUNCTION—[FLASH]
The Flash function is used to access PBX features
or Telco line features such as Call Waiting. The
Flash function is a 600 ms timed line break. If
the Flash function will be used often, store the
feature into memory located for easy access as
follows:
1. Lift the handset then press the STORE key.
2. Press the FLASH key.
3. Press the memory location where the
FLASH is to be stored.
4. Hang up the handset.
E200 AND E200TRM PHONES