MagTek IntelliStripe 350 - Manual (Page 13)

SECTION 2. INSTALLATION
The installation of the IntelliStripe 350 Desktop Motorized Reader consists of placing the unit on
a flat surface, plugging the I/O connector into the host serial port, and plugging the Power
Supply into the I/O cable and into a wall receptacle.
COMPONENTS
Components of the unit for installation are shown in Figure 2-1.
Magnetic Stripe
Down And
To The Right
LED
Screw Slots (4) For
Retaining Upper
And Lower Covers
Bottom View
Power Supply And Cable
Two Of Four
Foot Pads
Lower Cover
AC Cable
AC Cable
I/O Cable To
IntelliStripe 350
9 Pin Connector
To Host
3 Prong Connector
Upper Cover
Ejector Rod
Figure 2-1. IntelliStripe 350 Components
7