MagTek IntelliStripe 350 - Manual (Page 18)

IntelliStripe 350, Desktop Motorized Reader
To remove a jammed card proceed as follows:
1. Remove the Ejector Rod by sliding it from under the retaining tabs as shown in Figure 3-1.
Foot Pads (4)
Bottom View
Agency
Approvals
Notch
Ejector Rod
Serial
Number
Sticker
Pull Out Ejector Rod
Figure 3-1. Ejector Rod Removal
2. Look into the slot in the back of the unit, shown in Figure 3-2, to see the jammed card. This
will show the approximate position where the notch on the Ejector Rod will be inserted.
12