MagTek IntelliStripe 350 - Manual (Page 7)

1
SECTION 1. FEATURES AND SPECIFICATIONS
The IntelliStripe 350, Desktop Motorized Reader, can read the mag-stripe data from financial
cards and drivers licenses, as well as provide ISO 7816/ EMV level 1 support for communicating
to T=0, T=1 Smartcards. Support for many popular Memory cards is also provided.
The Reader communicates with a Host via an RS-232 serial interface, and uses a proprietary
MCP protocol and command set, which has been developed by MagTek. Windows Drivers for
the MCP protocol are available and can support most Windows operating systems.
CONFIGURATION
Part numbers and descriptions for the basic configuration are shown in the table below. All extra
items must be ordered separately.
Part
Number
Description
16050313 IntelliStripe 350, 3TK, C Bezel, RS-232 & USB Interface, Stripe
Down, Chip Up, EMV Compliant, cables ordered separately.
16051412 RS-232 I/O Cable, 7-pin connector connects to host 9-pin
connector with 12V/Ground connector for Power Supply.
16051433 USB Cable, 6’ MagTek Gray
64300080 Power Supply, 100V through 240V regulated with 2.5mm plug.
71100001 AC power cord, P/N is for use in North America. Other users must
supply their own cord, or contact MagTek for international cords.
STANDARD FEATURES
Standard features of the IntelliStripe 350 are as follows:
•
Motorized transport
•
RS-232 and USB interface
•
Status LED
•
Flash upgradable
•
8 Smart Card Contacts for reading ISO 7816 contact locations
•
Supports all popular magnetic stripe track combinations
•
Front Card Gate prevents coins, dust, moisture, and debris from entering the unit – gate
resists opening except when ISO-size card enters the unit.