MagTek IntelliStripe 350 - Manual (Page 15)

Section 2. Installation
The Power Supply, P/N 64300080, 100V
−240V regulated, 12VDC, with 2.5 mm plug is shown
in Figure 2-3. The AC power cord, P/N 71100001, is for use in North America. Other users must
supply their own AC cord, or contact MagTek for international cords.
3 Prong
Connector
12VDC Plug
GND
Auto Range
Power Supply
North American
100V–240V
Power Cord
Figure 2-3. Power Supply and AC Cable.
REAR PANEL
The Rear Panel is shown in Figure 2-4 (for the RS-232 connection) and Figure 2-5 (for the USB
connection). The cables and tie wraps must be ordered as separate line items when ordering the
reader. For the RS-232 configuration, the power connector can either be connected to the rear of
the reader or into the power jack on the RS-232 cable.
Tie Wrap Cable Clamps
Back View
Factory
Use Only
7-Pin
Connector
Pin 7
Slot For Ejector Rod
To Remove Cards
Tie Wrap
Pin 1
Power Connector
USB Connector
Figure 2-4. Rear Panel – RS-232 Connection
9