MagTek IntelliStripe 310™ - Manual (Page 18)

IntelliStripe 310 Command Reference
12
SOFTWARE RESET COMMAND
Command ID: 80 (Hex)
Description:
This command is used to reset the device. This will put the device in its power on state. The
device should be allowed time to power up (we recommend three seconds) before trying to
communicate with the device.
Request Message Data: None
Response Message Data: None
Response Message Result Codes:
Success = 00 (Hex)
The command completed successfully.
Example Request:
Field MTYP APPL CMND RC
Byte 1 2 3 4
Value (Hex) 00 00 80 00
Example Response:
Field MTYP APPL CMND RC
Byte 1 2 3 4
Value (Hex) 40 00 80 00