MagTek IntelliStripe 310™ - Manual (Page 31)

25
SECTION 6. TRANSPORT APPLICATION
Application ID: 82 (Hex)
Description:
This application deals with card transportation and magnetic stripe data acquisition. This
application works closely with the Magnetic Stripe application. The Magnetic Stripe application
deals with decoding and presenting magnetic stripe card data.
GET/SET PROPERTY COMMANDS
Get Property Command ID: 00 (Hex)
Set Property Command ID: 01 (Hex)
Description:
These commands are used to retrieve and set the value of application properties. Details of these
commands are described in the Generic command section of this document. The following
describes each property this application supports.
INDICATORS PROPERTY
Property ID: 00 (Hex)
Property Type: Dword
Power Up/Reset Value: Dependent on indicator states
Get/Set support: Get
Description:
This property is used to get the transport indicators. These indicators are used to determine the
state of the transport and the location of any cards present in the transport.