MagTek MINI MICR WEDGE - Manual (Page 11)

3
SECTION 2. INSTALLATION
The installation for the MICR Reader is as follows:
REQUIREMENTS
The following is required for the Installation:
•
MINI MICR WEDGE With Optional 3-Track or 2-Track MSR
•
Interface Cable, Mini DIN 6 pin, Part Number 22517501 or
Interface Cable, Large DIN 5 pin, Part Number 22517503
•
AC Power Adapter with Cable, 120VAC to 12 VAC, 1 Amp, Part Number 64300050
PROCEDURE
To install the MICR Reader, refer to Figure 2-1 and perform the following steps:
Figure 2-1. MICR Interface Cabling
1.
Power off the PC.
2.
Disconnect the keyboard from the PC.
3.
On the interface cable, connect the 9-pin male DIN connector to the MICR Reader.