Swb - switch b command, Swb parameters, Keypad type – MagTek MINI MICR WEDGE User Manual
Page 20: Table 3-1. led indicators
MINI MICR WEDGE with 3-Track MSR
12
SWB - SWITCH B COMMAND
The SWB command controls the message format, shown in Table 4-3. The data for this command
consists of 8 ASCII bits (“0” = hex 30 and “1” = hex 31).
To execute, send the SWB command as follows:
SWB 01010101<ENTER>
(with
data)
or
SWB <ENTER>
(without data)
When sending data, all 8 bits must be provided. The MICR Reader will execute the command but
it will not reply. The new settings become effective immediately. To make this command
permanent, use the SA (Save) command described at the end of this section.
If no data is sent, the MICR Reader responds with the current settings for SWB.
Table 4-3. SWB Command
BIT PARAMETERS
7
6
5
4
3
2
1
0
0
Trailing
<ESC>:
No
1
Trailing
<ESC>:
Yes
0
0
0
<ENTER> key: No - Do Not Send
0
0
1
<ENTER> key: Yes - Default single
1
0
1
<ENTER> key: Yes - Default double
0
1
1
<ENTER> key: Yes - Custom single
1
1
1
<ENTER> key: Yes - Custom double
0
<ETX>:
No
1
<ETX>:
Yes
0
Leading
<ESC>:
No
1
Leading <ESC>: Yes
0
<STX>:
No
1
<STX>:
Yes
0
Sent
Status:
No
1
Sent
Status:
Yes
SWB PARAMETERS
The SWB functions are listed in Table 4-3 and described below.