Horner APG XL4 OCS HE-ETN300 - Manual (Page 15)

SUP0740-07 CH.3
11/30/2009 Page 15 of 98 # 958
CHAPTER 3: GENERAL CONFIGURATION
Note: The following configuration is required for all applications regardless of the protocols used.
Additional configuration procedures must be performed for each protocol used as described in the
configuration sections of the next several chapters.
3.1 Ethernet Module Configuration
To configure the Ethernet Module, use Cscape Programming Software to perform the following
six steps:
1. On the main Cscape screen, select the Controller menu and its I/O Configure sub-menu to
open the I/O Configuration dialog (Figure 3.1 or Figure 3.2).
2. If configuring a different OCS Model than the one shown in the I/O Configuration dialog, click
on the topmost Config button, select the desired OCS Model, and then click OK.
Note: Figure 3.1 shows a typical I/O Configuration dialog for OCS Models, which have Ethernet
Modules built-in. For these models, step 3 should be skipped.
Figure 3.2 shows a typical I/O Configuration dialog for other OCS Models, in which the
Ethernet Module is a user-installable option. For these models, step 3 must be performed,
to configure the Ethernet Module into a SmartStack I/O slot.
Figure 3-1 – Hardware Configuration Dialog – OCS Models With Built-In Ethernet