Flytec 3040/TT34 * - Manual (Page 10)

Operation manual Flytec 3040 Balloon 9
7. Time functions
This unit has two time functions: a real-time clock, and a stopwatch
The change between the three functions in the bottom
display can be done with a short press of the button
CHRONO
The activated time display appears with the indicator
arrow on Chrono.
ENV TEMP
AMB TEMP
CHRONO
7.1 real time clock
RTC:
If the indicator arrow points to CHRONO, the Real-time is
displayed in the lower display field.
Note: When the stopwatch is activited, the stopwatch time
instead real-time is displayed.
Set mode time:
Pressing the Chrono Key for three seconds, enter the
instrument into Time-Set-Mode.
1. In the top display hh:mm appears. In the bottom display
the current time hours and minutes flashes.
Changehouers and minutes with the Up or Down key.
Confirm the correct input by pressing the button Chrono.
16:25
◄
◄
2645
ENV TEMP
AMB TEMP
CHRONO
16:25
◄
◄
2645
2. In the top display dd:mm appears. In the bottom display
the current time hours and minutes flashes. Change day
and mounts with the Up or Down key.
Confirm the correct input by pressing the button Chrono.
3. The last setting is the year (YYYY) .
4. Pressing the button Chrono will store the time seting and
also leave the setting mode
7.2 Stop watch (Chrono)
The stopwatch can by activated by pressing the Start / Stop key. A running stopwatch is
indicated with a flashing arrow, the arrow stays steadily when the Chrono is stopped.
Pressing the LAP button frezes the display and allowing the elapse time to that point to be
read, pressing the LAB key a second time, switches the display back to the runing
stopwatch. During the LAP-time is diplayed, the time is still continues running in the
background.
By pressing the STOP button, the current time measurement is stopped and started by
pressing the button again. This function can be determined to messure the exact flight
time, non flight times (such as stopovers) can be excreted. Pressing the Reset key (when
the clock is stopt), reset the stopwatch to zero, and will automatically switch back to real
time display.
Note: The stopwatch functions can be used at any time, even the display shows the
temperatur!