Flytec 3040/TT34 * - Manual (Page 5)

Operation manual Flytec 3040 Balloon 4
2.1.3 Configuration mode
This mode allows for example a QNH adjust (age deviation of the pressure sensor). This
mode is accessed by pressing a specific keyboard key combination, see QNH Correction
Annex page 18
.
3. Switching the instrument ON / OFF
3.1 Switching the Instrument On
The 3040 unit is equipped with two independent 9V batteries. The device is switched on
with the main power switch to the position ON1 or ON2 (battery 1 or battery 2)
After switching ON, the device performs a self test
and displays for 10 seconds the the battery condition
of the activated battery in the variometer screen.
3.2 Power ON display
The power On dispay shows the battery status, and
the current time and date
18:52
hh:nn
Po
Battery status (Power)
5 = full
0 = empty
hh:mm = hours, minutes
dd:mm = day, mouth
YYYY = year
An insufficient batery power is indicated by lighting
up of one or more segments in the red sink
variometer scale. During flight, a low battery alarm
appers every 5 seconds.
3.3 Switching the Instrument OFF
3.3.1 By hand:
Slide the main power switch to the center (OFF) position
3.3.2 Automatically switch Off:
The 3040 will automatically power down if no flight activities (less than 25m altitude
change) is detected within 30 minutes of power on.
Note: For a restart, after an atomatically switch off, the main power switch must be switch
to the center OFF position for at least 2 sec.