Flytec 3040/TT34 * - Manual (Page 13)

Operation manual Flytec 3040 Balloon 12
8.4 Personal temperature alarm
If the given alarm level is reached the personal temperature alarm goes on. Then an
impulse tone is activated. By pressing the TEMP ALARM OFF key the alarm can be
switched off for 20 seconds. The alarm re sounds until the balloon envelope temperature
is out of the alarm level bench again.
8.4.1 Set temperature alarm threshold
The temperature alarm can be set between 40 °C (104° F) an the maximum envelope
temp which is set by the envelope manufacturer
By pressing the TEMP ALARM key for 4 sec., the
temperature alarm function is activated. (Display is
blinking)
105.0
By pressing an arrow key for a short time the alarm
level can be adjusted by one temperature unit steps.
While pressing this key continuously, the displayed
value is changing until the pressure on this key is
released.
A short press on the ENV TEMP key, will save the
alarm threshold and also leave the setting mode.
8.5 Maximum Temp Alarm
The maximum envelope temperature is a default value recommended by the manufacturer
and can not be manipulated. If the pilot reaches the maximum alarm level a temperature
alarm will always go on. The alarm sound will be heard as a constant tone until the
maximum envelope temperature is not reached any more.
The maximum envelope alarm can not be switched off
8.6 Deactivate envelope temperature function
In case no temperature transmission unit is in Use, the radio receiver for the TT34 and the
ENV. Temp. function can be switched off, by switching the REC Switch to OFF.
When switched off, the display can not be set to ENV TEMP, only AMB. TEMP and
Chrono can be selected!