Flytec Windwatch Pro - Manual (Page 20)

20 Altimeter
Altimeter Screens
Absolute and relative altimeter display
The top line shows the current altitude (elevation). The middle
line shows the altitude difference since the last reset of ALT2.
This relative altimeter can quickly be zeroed with a long press
of the RES key so that a vertical ascent/descent can be easily
measured. The bottom line shows the rate of ascent/descent
per hour. The units for this screen can be toggled between m
and m/h or ft and ft/h with a short press of the ▼ or ▲ key.
1625
70
218 m/h
m
ALT2
Cumulative ascent and descent display
2314
13965
-17825
m
m
The top line shows the current altitude (elevation). The middle
line shows the accumulated ascent and the bottom line shows
the accumulated descent since the last reset. Reset of the
ascent and descent totals is performed by a long press of the
RES key. Units (ft or m) can be toggled with a short press of the
▼ or ▲ key.
AutoSet display
The top line shows the current altitude (elevation). The middle
line indicates the altitude that will be set by the AutoSet
function (if enabled). The bottom line shows the time when
AutoSet will set the altitude shown on the middle line (if
enabled). See the detailed instructions in section on AutoSet
below. AutoSet is toggled on/off with a long press of the ▼ or
▲ key.