Flytec Windwatch Pro - Manual (Page 5)

Introduction 3
4
SEC
Set-Mode for the Main Display Screen
A long press (4 seconds) of the MENU key brings up the set-mode for the current main function
shown on the upper line of the display. With the WWP in set-mode, the value to be set will be
flashing and can be adjusted with the UP and DOWN keys.
Example: When the WWP is in the Altimeter screen, pressing the MENU key for 4 seconds
allows the altitude to be adjusted.
Use a short press of the MENU key to escape set-mode – or, if no key is pressed for 7 seconds,
set-mode is automatically escaped.
Set-Mode for Secondary Functions 4
SEC
A long press (4 seconds) of the SUB key gives access to the set-mode for that secondary
function (the values on middle and lower lines of the display). When in set-mode, the value to be
set will flash and can be adjusted with the
S and T keys.
Example: When the WWP is in the Altimeter screen, pressing the SUB key for 4 seconds allows
the adjustment of the Relative Altimeter.
A short press of the SUB key will accept the value that is flashing and will cause the next value
that can be adjusted (if any) to flash. If there is no further value to be adjusted, a subsequent
press of the SUB key will escape set-mode – or, if no key is pressed for 7 seconds, set-mode is
automatically escaped.
Select Measuring Units
A short press of the S or T key in any display screen will change the measuring units. If there
are more than two possibilities, subsequent shot presses will scroll through the choices.
Example: In the Altimeter screen, a short press of either arrow key will change the display from
meters (m) to feet (ft).
Start - Stop - Reset
When the WWP is in the Stopwatch screen, the left key is used to start and stop the stopwatch.
A short press of the right key marks the interval time, whereas a long press resets the
stopwatch to zero.
A long press of the RES key resets the primary displayed value of the current function shown on
the display. Example: in the Altimeter screen, the reference altimeter can be reset to zero with a
long press of the RES key.