Campbell Scientific CR510 Basic Datalogger - Manual (Page 60)

SECTION 3. INSTRUCTION SET BASICS
3-12
26 Compile EXIT LOOP without
LOOP
27 Compile IF CASE without BEGIN
CASE
30 Compile IF and/or LOOP nested
too deep
31 Run Time SUBROUTINES nested
too deep
32 Compile Instruction 3 and interrupt
subroutine use same port
40 Editor Instruction does not exist
41 Editor Incorrect execution
interval
60 Compile Insufficient Input Storage
92 Compile Instruction 92, intervals in
seconds: Time into Interval
> 59 or Interval > 60
94
∗
D MODE Program Storage Area
full
95
∗
D MODE Program does not exist in
Flash memory
96
∗
D MODE Addressed device not
connected or wrong
address (see Table 1.8-2)
97
∗
D MODE Data not received within
30 seconds
98
∗
D MODE Uncorrectable errors
detected
99
∗
D MODE Wrong file type or editor
error