Campbell Scientific CR510 Basic Datalogger - Manual (Page 66)

SECTION 4. EXTERNAL STORAGE PERIPHERALS
4-6
TABLE 4.5-1.
∗∗∗∗
9 Commands for Storage Module
COMMAND DISPLAY DESCRIPTION
1 01: 0000 RESET, enter 248 to erase all data and programs. While erasing,
the SM checks memory. The number of good chips is then
01: XX displayed (6 for SM192, 22 SM716).
3 03: 01 INSERT FILE MARK, 1 indicates that the mark was inserted, 0
that it was not.
4 04: XX DISPLAY/SET MEMORY CONFIGURATION enter the
appropriate code to change configuration 0=ring, 1=fill & stop
5 DISPLAY STATUS (A to advance to each window)
01: ABCD Window 1:
AB Storage pointer location (chip no.)
CD Total good RAM chips (1-22)
02: ABCD Window 2:
AB Display pointer location (chip no.)
C Unloaded Batt. Chk. 0=low, 1=OK
D No. of Programs stored (Max=8)
03: A0CD Window 3:
A Errors logged (up to 9)
0 Not Used
C Memory Config. (0=ring, 1=fill&stop)
D Memory Status (0=not full, 1=full)
04: XXXXX PROM signature (0 if bad PROM)
6 06: 0X BATTERY CHECK UNDER LOAD (0=low, 1=OK)
7 07: 00 DISPLAY DATA, Select the Storage Module Area with these codes:
0 Dump pointer to SRP
1 File 1, current file
2 File 2, previous to file 1
3 File 3, previous to file 2
4 File 4, previous to file 3
5 File 5, previous to file 4
7 Display pointer to SRP
9 Oldest data to SRP
1-5 will loop within file boundaries, 0,7,9 allow display to
cross boundaries
07:XXXXXX SM location at end of area selected. Key A to advance to first
data. If another location is keyed in SM will jump to 1st start of
array following that location.
Review data with:
A Advance and display next data point
B Back-up one data point
# Display location, C to return to data
#A Advance to next start of Array
#B Back-up to start of Array
#D Return to
∗
9 command mode
8 DUMP TO ANOTHER STORAGE MODULE
08:00 Select Area as in 7 above
01:XXXXXX First Loc. in area selected/Enter Loc. to start dump
02:XXXXXX Final Loc. in area selected/Enter Loc. to end dump
03:XX Enter destination SM address
9 DISPLAY ADDRESSES OF CONNECTED SM
XXXXXXXX 1 = occupied, 0 = unoccupied
87654321 (Addresses 8-1 from left to right)
10 CHANGE ADDRESS
10:0X X is current address, enter address to change to (1-8)