Campbell Scientific PVS4100/4120/4150 Portable Automatic Samplers - Manual (Page 51)

Section 5. Programming
5-11
5.3.3 START DELAY using Pulse Input
The following sequence of entries are made
on the Touchpad to create a future starting
time for the operation of the Sampler. The
ACTIVE SETTINGS are not being altered.
1. Press the SET key.
2. Press the START DELAY key.
3. Press an ARROW key. Continue until
Pulse Input is shown on the display.
4. Press the ENTER key.
The display will show a new screen
containing the option title PULSE INPUT
on the top line and a 7 digit number with the
leftmost digit flashing as an input prompt.
To set the number of pulses required to be
input before a sample program is started, use
the ARROW keys to move the flashing
prompt until it is over the digit requiring
change.
Press a number key (0-9) to replace any
existing number and advance the flashing
prompt to the next digit to change. Replace
digits as required, then press ENTER.
The display will echo the last entry with
<ENTERED>.
Any wrong entries will require re-entry. If
ENTER has not been pressed, reposition the
prompt over the incorrect digit and replace
it. After ENTER has been pressed, the entire
entry must be redone from the beginning
(press SET).