Campbell Scientific PVS4100/4120/4150 Portable Automatic Samplers - Manual (Page 80)

Section 5. Programming
5-40
The controller has now been given a new
value for PINCH VALVE. The new value
resides in the NEW ENTRIES area of the
controller memory. To make these changes
active, press the RESTART key, then again
press it to confirm your choice. The
controller will then be set to perform in
conjunction with the parameters
programmed under the START DELAY,
SAMPLE INITIATION and PROGRAM
TYPE settings.
Summary of Sequence:
SET, OTHER OPTIONS, ARROW(S), ENTER, ARROW(S), ENTER,
RESTART, RESTART.
5.6.5 OTHER OPTIONS - Fault Shutdown
The following sequence of entries are made
on the Touchpad to describe how the
Sampler controller is to operate some of the
hardware specified in its configuration. The
ACTIVE SETTINGS are not being altered.
1. Press the SET key.
2. Press the OTHER OPTIONS key.
3. Press an ARROW key. Continue until
Fault Shutdown is shown on the display..
4. Press the ENTER key.
Fault Shutdown is used to control whether the sampler will cease taking
samples after a predetermined number of unsuccessful attempts.