Campbell Scientific PVS4100/4120/4150 Portable Automatic Samplers - Manual (Page 72)

Section 5. Programming
5-32
Press ENTER. The display now reads
PROGRAM TYPE <ENTERED>.
The controller has now been given a new
value for PROGRAM TYPE. The new
value resides in the NEW ENTRIES area of
the controller memory. To make these
changes active, press the RESTART key,
then again press it to confirm your choice.
The controller will then be set to perform as
a Multi-Composite Sampler in conjunction
with the parameters programmed under the
START DELAY and SAMPLE
INITIATION variables.
Summary of Sequence:
SET, PROGRAM TYPE, ARROW(S), ENTER, ENTER, ##, ENTER,
RESTART, RESTART.
5.5.7 PROGRAM TYPE - Timed Step
The following sequence of entries are made
on the Touchpad to describe how the
Sampler controller is to store the samples it
takes, in the hardware specified in its
configuration. The ACTIVE SETTINGS are
not being altered.
1. Press the SET key.
2. Press the PROGRAM TYPE key.
3. Press an ARROW key. Continue until
Timed Step is shown on the display (for
storage in multiple container array).