Campbell Scientific PVS4100/4120/4150 Portable Automatic Samplers - Manual (Page 67)

Section 5. Programming
5-27
can be chosen. If no change in the displayed
value is required, the value has been
changed or the value is zero, pressing
ENTER will advance the day of the week.
Therefore...
Press ENTER. Repeat the above procedures
until all the required containers, on their
respective days, have been allocated, or the
7 days of the week are all selected. The total
number available is never allowed to be
more than the amount registered as the two
digit representation of the hardware
configuration in the “Total bottles 00” entry.
The display will echo the last entry with
PROGRAM TYPE <ENTERED>.
The controller has now been given a new
value for PROGRAM TYPE. The new
value resides in the NEW ENTRIES area of
the controller memory. To make these
changes active, press the RESTART key,
then again press it to confirm your choice.
The controller will then be set to perform as
a Daily Cycle Sampler in conjunction with
the parameters programmed under the
START DELAY and SAMPLE
INITIATION variables.
Summary of Sequence:
SET, PROGRAM TYPE, ARROW(S), ENTER, ARROW(S), ENTER, #,
ENTER, #, ENTER, #, ENTER, #, ENTER, #, ENTER, #, ENTER, #,
ENTER, RESTART, RESTART.
5.5.4 PROGRAM TYPE - Daily Cycle for Dual Station
Dual Station – Flip Flop Application Only (Single Controller, Two Metering
Chambers)
The following sequence of entries are made
on the Touchpad to describe how the
Sampler controller is to store the samples it
takes, when the hardware specified is
configured to deliver Samples from two
separate sources. The ACTIVE SETTINGS
are not being altered.