Campbell Scientific PVS4100/4120/4150 Portable Automatic Samplers - Manual (Page 55)

Section 5. Programming
5-15
5.3.6 START DELAY using Level Control
The following sequence of entries are made
on the Touchpad to create a future starting
time for the operation of the Sampler. The
ACTIVE SETTINGS are not being altered.
1. Press the SET key.
2. Press the START DELAY key.
3. Press an ARROW key. Continue until
Level Control is shown on the display.
4. Press the ENTER key.
The display will change to read “Minimum
Contact Time: 01 seconds”. The actual time
shown may be any two digit number. The
first digit will be flashing as a prompt for
input.
Press a number key (0-9). The number will
replace the current number and advance the
flashing prompt to the next digit. Press a
second number key (0-9). Repeat this
procedure if number is wrong, until desired
time is displayed. Press the ENTER key.
The display will echo the last entry with
START DELAY, <ENTERED>.