Agilent Technologies E4438C - Manual (Page 24)

Getting Started
Administration of Service Support Software
1-14
Adding Device Drivers
Follow these instructions to add test equipment device drivers to the program:
CAUTION This and the following procedures: Adding/Removing Device (Test Equipment) Drivers,
Adding/Removing Test Drivers, and Adding/Removing Datapacks are included for
informational purposes. These procedures should only be used when instructions are provided
describing which drivers or datapacks need replacement or removal.
1. Log into the software normally until the Select Test Equipment and Tests window is displayed.
2. Click the Cancel button to close the Select Test Equipment and Tests window.
3. Refer to Figure 1-6 . In the File drop-down menu, select Test Equipment Drivers.
Figure 1-6 Test Equipment Drivers in the File Drop-Down Menu
This selection allows for the addition or removal of software drivers for the test equipment being used to
verify the performance of the DUT.
4. To add a device driver to the existing list of test equipment drivers, click the Add button ( Figure 1-7 ).