Sierra Monitor Company FS-8700-48 - Manual (Page 32)

FS-8700-48 Fike Cheetah Manual Page 33 of 37
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: [email protected]
# Description Notes
84 network silence history stored when a silence command is recorded from cheetah net
85 network drill presnt drill state activated from network - all zone only.
86 abort restored abort state for this zone de-activated.
87 abort present abort state for this zone activated.
88 pre-alarm1 restored pre-alarm 1 state for this zone de-activated.
89 pre-alarm1 present pre-alarm 1 state for this zone activated.
90 pre-alarm2 restored pre-alarm 2 state for this zone de-activated.
91 pre-alarm2 present pre-alarm 2 state for this zone activated.
92 network drill restor drill state restored from network - all zone only.
93 alarm present alarm state for this zone activated.
94 periph #aa missing peripheral device of id#aa is missing.
95 pre-discharge pre-discharge state for this zone activated.
96 periph #aa return peripheral device of id#aa has returned on line.
97 release release state for this zone activated.
98 zone enabled zone disable state for this zone de-activated.
99 zone disabled zone disable state for this zone activated.
100 watermist inactive not used since release state never clears
101 watermist active watermist state for this zone activated
102 network alarm unsil network command - unsilence alarms
103 network superv unsil network command - unsilence supervisories
104 checksum ok -----
zone configuration checksum error restored. zone number appended to this
message.
105 checksum error ----- zone configuration checksum error. zone number appended to this message.
106 network troubl unsil network command - unsilence troubles
107 vesda not configured trouble event stored when the hli is present but no vesda is configured.
108 vesda configur clear trouble clear event for the above trouble.
109 config menu exited trouble clear event when the configuration menu has been exited
110 aux1 power restored auxiliary power input trouble restored - main board
111 aux1 power trouble auxiliary power input trouble - main board
112 aux2 power restored auxiliary power input trouble restored - power module
113 aux2 power trouble auxiliary power input trouble - power module
114 aud switch disabled enable/disable switch for audibles is in the disable position
115 aud switch restored enable/disable switch for audibles has returned to the enable position
116 diagnostics entered indicates the operator has accessed the diagnostic menu selections
117 zone disable restore frcm assigned to zone disable function has cleared
118 zone disable active frcm assigned to zone disable function has activated
119 internal fault device trouble from the 0x08 polling command
120 int fault restored trouble restored from the 0x08 polling command
121 wiring fault-open open circuit fault on supervised circuit: frcm/som/srm
122 wiring fault-short short circuit fault on frcm/som/srm
123 acknowledge switch acknowledge switch pressed.
124 test point bad analog device fire test point is out of hochiki specified range.
125 calibration restored calibration fault has been restored. device now has valid calibration data.