Sierra Monitor Company FS-8700-48 - Manual (Page 33)

FS-8700-48 Fike Cheetah Manual Page 34 of 37
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: [email protected]
# Description Notes
126 calibration fault fault detected during calibration of this device.
127 configure restored fault restored from som/r2m/srm configuration trouble.
128 configure fault fault detected when configuring som/r2m/srm.
129 reconfigured device addressable device has been configured
130 enabled device addressable device has been enabled.
131 disabled device addressable device has been disabled.
132 enabled loop 1 loop 1 has been enabled.
133 disabled loop 1 loop 1 has been disabled.
134 enabled loop 2 loop 2 has been enabled.
135 disabled loop 2 loop 2 has been disabled.
136 enabled loop 3 loop 3 has been enabled.
137 disabled loop 3 loop 3 has been disabled.
138 enabled loop 4 loop 4 has been enabled.
139 disabled loop 4 loop 4 has been disabled.
140 enabled zone ----- zone enabled. zone number appended to this message.
141 disabled zone ----- zone disabled. zone number appended to this message.
142 enabled ckt ----- board level output circuit enabled. circuit number appended to this message.
143 disabled ckt ----- board level output circuit disabled. circuit number appended to this message.
144 loop 1 calibration all configured analog devices on loop 1 have been calibrated.
145 loop 2 calibration all configured analog devices on loop 2 have been calibrated.
146 loop 3 calibration all configured analog devices on loop 3 have been calibrated.
147 loop 4 calibration all configured analog devices on loop 4 have been calibrated.
148 l1 open class a class a wiring has an open circuit trouble - loop 1.
149 l2 open class a class a wiring has an open circuit trouble - loop 2.
150 l3 open class a class a wiring has an open circuit trouble - loop 3.
151 l4 open class a class a wiring has an open circuit trouble - loop 4.
152 l1 class a restored class a wiring trouble has restored to noramal - loop 1.
153 l2 class a restored class a wiring trouble has restored to noramal - loop 2.
154 l3 class a restored class a wiring trouble has restored to noramal - loop 3.
155 l4 class a restored class a wiring trouble has restored to noramal - loop 4.
156 walktest active panel has enterred the walktest mode.
157 walktest expired walktest mode has expired.
158 cfg resto 1: mr----- config error #1 restored. zone number appended to this message.
159 cfg error 1: mr----- config error #1 (no manrel in this zone). zone number appended to this message.
160 cheetah network device clear
161 cheetah network device activation
162 config resto 3: al v config error #3 restored.
163 config error 3: al v config error #3 (alarm verification on device in a suppression zone) trouble.
164 system power low system power below voltage level for reliable operation.
165 system power ok system power low trouble restored.
166 checksum error ----- config checksum error trouble: devices & loops (loop number appended).
167 checksum ok ----- config checksum error trouble restored: devices & loops (loop number appended).