AMT Datasouth documax 3300 - Manual (Page 160)

User’s Guide
System Administration Features D-4
Menu 10: System Control
Displayed Function Values Description of Features
Reset Quick List Resets the list of features accessed by the Quick
Access key to the default features.
Add Quick FTR Use Value ▲ ▼ keys to select feature to add to Quick
Access key. Press Enter key.
This feature can now be accessed using Quick Access
key. Up to seven features can be available with the
Quick Access key.
Delete Quick FTR Use Value ▲ ▼ keys to select feature to delete to
Quick Access key. Press Enter key.
This feature will no longer be accessible from the
Quick Access key.
Ribbon Life 1- 50M The value in this feature indicated the total number of
characters (in millions) that the RIBBON USED
feature uses to calculate the percent ribbon used.
Replace Rib 1 to 100 This value indicates when the printer displays the
REPLACE RIBBON message. This feature
monitors the Ribbon Used feature and must be set
to a value greater that the CHECK RIB feature.
Check Rib 1 to 100 This value indicated when the printer displays the
CHECK RIBBON message. This feature must be
set to a value less that the REPLACE RIB feature.
This feature monitors the Ribbon Used feature.
Config Tractor
Trac-Fric
Dual Trac
Trac Roll
Sets the mechanical configuration of the printer.
This is set to the correct value at the factory.
This feature is useful if the firmware or main
electronics controller board is replaced.
The value is automatically saved.