Preface – Allied Telesis AT-S94 CLI (AT-8000S Series) User Manual
Page 15
Preface
Page 14
Preface
This guide describes how to configure an AT-8000S Series switch with AT-S94 V2.0.0 firmware using the
command line interface. The commands are grouped by topic into the following chapters:
•
Chapter 1. "Using the CLI" — Describe the CLI basic structure and command usage.
•
Chapter 2. "ACL Commands" — Define MAC and IP based ACLs and ACL bindings.
•
Chapter 3. "AAA Commands" — Define the authentication method lists for servers.
•
Chapter 4. "Address Table Commands" — Register MAC-layer Multicast addresses, and handles MAC-
layer secure address to a routed port .
•
Chapter 5. "Clock Commands" — Show the configuration or status of the Simple Network Time Protocol
(SNTP).
•
Chapter 6. "Configuration and Image File Commands" — Display the contents of the currently running
configuration file, specify contents of image files.
•
Chapter 7. "DHCP Snooping Commands" — Contains parameters for enabling DHCP Snooping on the
device
•
Chapter 8. "Ethernet Configuration Commands" — Configure multiple Ethernet type interfaces.
•
Chapter 9. "GVRP Commands" — Display the GARP VLAN Registration Protocol (GVRP) configuration
information, enable GVRP globally or on an interface.
•
Chapter 10. "IGMP Snooping Commands" — Enable the Internet Group Management Protocol (IGMP)
snooping.
•
Chapter 11. "IP Addressing Commands" — Define a default gateway, set an IP address for interface,
delete entries from the host.
•
Chapter 12. "IPv6 Addressing Commands" — Define addressing commands for the IPv6 protocol.
•
Chapter 13. "Line Commands" — Display line parameters, enable the command history function, or
configure the command history buffer size.
•
Chapter 14. "DHCP Option 82 Commands" — DHCP with Option 82 attaches authentication messages to
the packets sent from the host. DHCP passes the configuration information to hosts on a TCP/IP network.
This permits network administrators to limit address allocation authorized hosts.
•
Chapter 15. "IP DHCP Relay" — Defines Dynamic Host Configuration Protocol (DHCP) relay features on
the router.
•
Chapter 16. "LACP Commands" — Specify LACP system and port priority and display LACP information.
•
Chapter 17. "LLDP Commands" — Define commands for use with LLDP.
•
Chapter 18. "Login Banner Commands" — Display login banner commands.
•
Chapter 19. "Management ACL Commands" — Define a permit or deny a rule, or configure a management
access control list.
•
Chapter 20. "PHY Diagnostics Commands" — Display the optical transceiver diagnostics.
•
Chapter 21. "Port Channel Commands" — Enter the interface configuration mode to configure a specific,
or a multiple port-channel.
•
Chapter 22. "Port Monitor Commands" — Start a port monitoring session, or display the port monitoring
status.
•
Chapter 23. "Power over Ethernet Commands" — Configure and display Power over Ethernet device
settings.
•
Chapter 24. "QoS Commands" — Enable Quality of Service (QoS) on the device, create policy maps, and
define traffic classifications