Allied Telesis AT-S63 - Manual (Page 528)

Chapter 30: SNMPv3 Commands
528 Section IV: SNMPv3
 You cannot define the storage type. New entries are automatically
assigned the storage type of nonvolatile.
 You must include all of the parameters.
 The parameters must be entered in the order shown above.
Example
In this example, the Target Parameters Table entry is called
“snmpv3mgr24” and the user name is “user444.” The security level is set
to authentication, the security model to the SNMPv3 protocol, and the
message processing to SNMPv3.
awplus> enable
awplus# configure terminal
awplus(config)# snmp-server targetparams snmpv3mgr24 user
user444 secure auth model v3 message v3