Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 623
AT-S63 Management Software Command Line User’s Guide
Section V: Spanning Tree Protocols
623
Description
This command configures the following MSTP parameter settings.
Hello time
Forwarding delay
Maximum age time
Maximum hop count
Force version of STP or normal MSTP
Configuration name
Revision level
Examples
The following command disables MSTP and returns all MSTP parameter
settings to their default values:
set mstp default
The following command sets the hop count to 10, the configuration name
to Engineering Region, and the reversion level to 2:
set mstp maxhops=10 configname="Engineering Region"
revisionlevel=2
The following command uses the FORCEVERSION parameter to
configure the bridge to use the MSTP parameters but to transmit only STP
BPDU packets:
set mstp forceversion=forcestpcompatible
Equivalent Command
purge mstp
For information, see “PURGE MSTP” on page 620. This command
performs the same function as the DEFAULT parameter.
AlliedWare Plus
Command
Syntax
To specify whether the bridge will operate with MSTP or in an STP-
compatible mode
forceversion 1|2|3
To specify the revision number of an MSTP region:
revision
revisionlevel