Allied Telesis AT-S62 - Manual (Page 10)

10
Preface
This guide describes how to configure an AT-8524M switch using the
AT-S62 command line interface. The commands are grouped by topic
into the following chapters:
❑ Chapter 1: Starting a Command Line Management Session on
page 15
❑ Chapter 2: Basic Command Line Commands on page 19
❑ Chapter 3: Enhanced Stacking Commands on page 29
❑ Chapter 4: Basic Switch Commands on page 35
❑ Chapter 5: Simple Network Time Protocol (SNTP) Commands on
page 64
❑ Chapter 6: SNMPv1 and SNMPv2 Community Strings and Trap
Commands on page 74
❑ Chapter 7: SNMPv3 Commands on page 92
❑ Chapter 8: Port Parameter Commands on page 150
❑ Chapter 9: MAC Address Table Commands on page 170
❑ Chapter 10: Port Trunking Commands on page 178
❑ Chapter 11: Port Mirroring Commands on page 186
❑ Chapter 12: Statistics Commands on page 190
❑ Chapter 13: File System Commands on page 194
❑ Chapter 14: File Download and Upload Commands on page 202
❑ Chapter 15: Event Log Commands on page 212