Allied Telesis AT-S62 - Manual (Page 150)

150
Chapter 8
Port Parameter Commands
This chapter contains the following commands:
❑ ACTIVATE SWITCH PORT on page 151
❑ DISABLE INTERFACE LINKTRAP on page 152
❑ DISABLE SWITCH PORT on page 153
❑ DISABLE SWITCH PORT FLOW on page 154
❑ ENABLE INTERFACE LINKTRAP on page 155
❑ ENABLE SWITCH PORT on page 156
❑ ENABLE SWITCH PORT FLOW on page 157
❑ RESET SWITCH PORT on page 158
❑ SET SWITCH PORT on page 159
❑ SET SWITCH PORT RATELIMIT on page 164
❑ SHOW INTERFACE on page 167
❑ SHOW SWITCH PORT on page 169
Note
Remember to save your changes with the SAVE CONFIGURATION
command.
Note
Refer to the AT-S62 Management Software User’s Guide for
background information on the port parameters.