Allied Telesis AT-S62 - Manual (Page 84)

Chapter 6: SNMPv1 and SNMPv2 Community Strings and Trap Commands
84
DISABLE SNMP COMMUNITY
Syntax
disable snmp community=”community”
Parameters
community Specifies an SNMP community string to disable on
the switch. This parameter is case sensitive. The
string must be enclosed in double quotes if it
contains a space. Otherwise, the quotes are
optional.
Description
This command disables a community string on the switch, while leaving
SNMP and all other community strings active. IP addresses of
management stations or trap receivers assigned to the community
string are also disabled. A disabled community string cannot be used by
a management workstation to access the switch.
Example
The following command deactivates the SNMP community string
“sw1200” and the IP addresses of any management stations and trap
receivers assigned to the community string:
disable snmp community=sw1200