Allied Telesis AT-S39 - Manual (Page 112)

Chapter 13: VLAN Commands
112
SET SWITCH SWITCHMODE
Syntax
set switch switchmode=tagged|basic
Parameters
vlanmode Specifies the switch’s mode. Specifying tagged means
the switch will support user-configured (port-based
and tagged) and multiple (801.Q compliant and non-
801.Q compliant) VLANs. Specifying basic means the
switch will support the Basic switch mode. The default
is basic. Only one mode can be active on a switch at a
time.
Description
This command configures a switch to support either port-based and
tagged VLANs or the Basic mode.
Note
This command performs exactly the same function as the SET
SWITCH VLANSTATUS command.
Example
The following command configures the switch to support the Basic
mode:
set switch switchmode=basic