Allied Telesis AT-S39 - Manual (Page 148)

Chapter 17: TACACS+ and RADIUS Commands
148
SHOW AUTHENTICATION
Syntax
show authentication
Parameters
None.
Description
Use this command to display the following information about the
authenticated protocols on the switch:
❑ The status of your authenticated protocol: enabled or disabled.
❑ The authentication protocol activated on your switch. Either
TACACS+ or RADIUS protocols may be active. The TACACS+
protocol is the default.
❑ The IP addresses of up to 3 authentication servers.
❑ The encryption key for each individual server, if defined.
❑ The global encryption code that applies to all authentication
servers.
❑ The length of the time, in seconds, before the switch assumes the
server cannot respond.
Example
The following command displays authentication protocol information
on your switch:
show authentication