Allied Telesis AT-S39 - Manual (Page 169)

AT-S39 Command Line Interface User’s Guide
169
The following command downloads a new AT-S39 configuration from
the management workstation to the switch:
load method=xmodem type=config
After entering this command, you must specify the location of the
AT-S39 configuration file stored on your workstation using your terminal
emulation program.
The following command downloads the AT-S39 image file on the master
switch to switches 1 and 4 in an enhanced stack. (Switch numbers are
displayed using the SHOW REMOTELIST command.)
load method=remoteswitch type=image
switchnumber=1,4
The following command downloads the AT-S39 configuration file on the
master switch to switch 2 in an enhanced stack.
load method=remoteswitch type=config
switchnumber=2
The following command downloads a configuration file using TFTP:
load method=tftp type=config
You are prompted for the IP address of the TFTP server and the name of
the file to download.