Nikon L810 - Manual (Page 184)

E 74
Re
fere
nce
S
ecti
o
n
Failed to take second
shot
When taking 3D pictures, the second shot could not be
successfully taken after the first shot.
• Try shooting again. After capturing the first image, move
the camera horizontally and frame the subject so that it is
aligned with the guide.
• In some shooting conditions, such as when the subject is
dark or low in contrast, the second image may not be
captured.
E5
–
Failed to save 3D image
The camera failed to save the 3D image.
• Try shooting again.
• Delete images.
• 3D images may not be created depending on the subject
or shooting conditions, resulting in failure to save them.
E5
31
–
Communications error
Error occurred during communication with printer.
Turn camera off and reconnect USB cable.
E20
System error
Error has occurred in camera’s internal circuitry.
Turn camera off, remove and reinsert batteries, and turn
camera on. If error persists, contact retailer or Nikon-
authorized service representative.
10, 22
Printer error: check
printer status.
Printer error.
Check printer. After solving the problem, select Resume and
press the
k button to resume printing.*
–
Printer error: check
paper
Specified size of paper is not loaded in printer.
Load the specified size of paper, select Resume, and press
the
k button to resume printing.*
–
Printer error: paper jam
Paper has jammed in printer.
Remove the jammed paper, select Resume, and press the
k
button to resume printing.*
–
Display Cause/Solution A