Shooting issues – Nikon L810 User Manual
Page 196
F
10
Te
chni
cal
Note
s and
In
dex
Characteristics of Digital Cameras
In extremely rare instances, unusual characters may appear in the monitor and the camera
may stop functioning. In most cases, this phenomenon is caused by a strong external static
charge. Turn the camera off, remove and replace the batteries, then turn the camera on again.
In the event of continued malfunction, contact your retailer or Nikon-authorized service
representative. Note that disconnecting the power source as described above may result in
the loss of any data not saved to internal memory or the memory card at the time the
problem occurred. Data already saved will not be affected.
Shooting Issues
Problem
Cause/Solution
A
Cannot switch to shooting
mode.
Disconnect the HDMI cable or USB cable.
No image captured when
the shutter-release button is
pressed.
• When camera is in playback mode, press the A
button, the shutter-release button, or the
b (e
movie-record) button.
• When menus are displayed, press the
d button.
• Battery is exhausted.
• When flash lamp flashes, flash is charging.
Cannot capture 3D image.
In some shooting conditions, such as when the
subject is dark or low in contrast, the second image
may not be captured or the 3D image may not be
saved.