Nikon P510 - Manual (Page 138)

E 8
Re
fere
nce
S
e
cti
o
n
Using 3D Photography
The camera takes one picture for each eye to simulate a three-dimensional image
on a 3D-compatible TV or monitor.
1
Frame the subject.
• The focus area that the camera focuses on can be
moved to areas other than the center of the frame. To
move the focus area, press the
k button before taking
the first picture, and then rotate the multi selector or
press
H, I, J, or K.
To adjust the following settings, press the k button to
temporarily cancel focus area selection, and then
adjust each setting.
– Focus mode (A (Autofocus) or p (macro close-up))
– Exposure compensation
2
Press the shutter-release button to take the first picture.
• The focus, exposure and white balance are locked after the first shot,
and R is displayed on the monitor.
3
Move the camera horizontally to the right
until the translucent guide is aligned with
the subject.
• To cancel shooting, press the k button.
4
Wait for the camera to automatically release the shutter.
• The camera automatically takes the second picture when it detects that the subject is
aligned with the guide.
• Shooting is canceled if the subject is not aligned with the guide within ten seconds.
Rotate the mode dial to y M d button M s 3D photography
6030 6030 6030
25m 0s 25m 0s 25m 0s
1/250 1/250 1/250 F5.6 F5.6 F3.0
Cancel Cancel Cancel