Nikon P510 User Manual
Page 245
F
9
Troubleshooting
Techn
ical
Not
e
s and Inde
x
b Electronically Controlled Cameras
In extremely rare instances, unusual characters may appear on the monitor and
the camera may stop functioning. In most cases, this phenomenon is caused by a
strong external static charge. Turn the camera off, remove and replace the battery,
then turn the camera on again. Note that disconnecting the power source as
described above may result in the loss of any data not recorded on the internal
memory or memory card at the time the problem occurred. Data already recorded
is not affected. In the event of continued malfunction, contact your retailer or
Nikon-authorized service representative.
Date not
appearing on
pictures even
when Print date is
enabled.
• A shooting mode that does not support print date is selected.
• Another function that is set now is restricting the print date.
• The date cannot be imprinted onto a movie.
80
–
Screen for setting
time zone and
date is displayed
when camera is
turned on.
Clock battery is exhausted; all settings were restored to their
default values.
Camera settings
reset.
Reset file
numbering
cannot be done.
Reset file numbering cannot be applied when the folder
number reaches 999 and there are images in the folder. Change
the memory card, or format the internal memory/memory card.
Monitor is turned
off, and the power-
on lamp flashes
quickly.
Battery temperature is high. Turn off camera, and allow battery to
cool down before resuming use. After the lamp flashes for three
minutes, the camera turns off automatically, but you can also
press the power switch to turn it off manually.
Camera
temperature rises.
When functions such as movie recording or sending images
using an Eye-Fi card are used for a long time, or when the camera
is used in a location with a high ambient temperature, the
camera temperature may rise. This is not a malfunction.
Problem
Cause/Solution
A