Nikon P310 - Manual (Page 220)

E 100
Error Messages
Re
fere
nce
S
ect
io
n
* See the instruction manual provided with your printer for further guidance and information.
The flash is lowered.
The flash is not raised during the scene auto selector.
Slide the
K (flash pop-up) control to raise the flash. The
camera can still shoot normally with the flash lowered if you do
not wish to use it.
39, 60
Lens error
Lens is not operating properly.
Turn camera off and then on again. If error persists, contact
retailer or Nikon-authorized service representative.
21
Communications
error Error occurred during communication with printer.
Turn off camera and reconnect the USB cable.
E27
System error
Error has occurred in camera’s internal circuitry.
Turn off camera, remove and reinsert battery, and turn on
camera. If the error persists, contact retailer or Nikon-authorized
service representative.
21
Printer error: check
printer status.
Printer error
Check printer. After solving the problem, select Resume and
press the
k button to resume printing.*
–
Printer error: check
paper
Specified size of paper is not loaded.
Load the specified size of paper, select Resume and press the
k button to resume printing.*
–
Printer error: paper
jam
Paper has jammed in the printer.
Remove the jammed paper, select Resume and press the
k
button to resume printing.*
–
Printer error: out of
paper
No paper is loaded in the printer.
Load the specified size of paper, select Resume and press the
k button to resume printing.*
–
Printer error: check
ink
Ink error
Check ink, select Resume and press the
k button to resume
printing.
*
–
Printer error: out of
ink
Ink cartridge is empty.
Replace ink cartridge, select Resume and press the
k button
to resume printing.
*
–
Printer error: file
corrupt An error caused by the image file has occurred.
Select Cancel and press the
k button to cancel printing.
–
Display Cause/Solution A