Error messages, 0 256), turn the camer – Nikon D5300 User Manual
Page 276
256 Technical Notes
Error Messages
This section lists the indicators and error messages that appear in the viewfinder and
monitor.
A
Warning Icons
A flashing
d in the monitor or s in the viewfinder indicates that a warning or error message
can be displayed in the monitor by pressing the
W (Q) button.
Indicator
Solution
0
Monitor
Viewfinder
Lock lens aperture ring at
minimum aperture (largest
f/-number).
B
(flashes)
Set lens aperture ring to minimum aperture
(highest f-number).
Lens not attached
F/s
(flashes)
• Attach non-IX NIKKOR lens.
• If non-CPU lens is attached, select mode M.
Shutter release disabled.
Recharge battery.
d/s
(flashes)
Turn camera off and recharge or replace
battery.
This battery cannot be used.
Choose battery designated
for use in this camera.
d
(flashes)
Use Nikon-approved battery.
Initialization error. Turn
camera off and then on
again.
d/k
(flashes)
Turn camera off, remove and replace battery,
and then turn camera on again.
Battery level is low.
Complete operation and turn
camera off immediately.
—
End cleaning and turn camera off and
recharge or replace battery.
Clock not set
—
Set camera clock.
No SD card inserted
S/s
(flashes)
Turn camera off and confirm that card is
correctly inserted.
Memory card is locked.
Slide lock to “write” position.
(
(flashes)
Memory card is locked (write protected). Slide
card write-protect switch to “write” position.
This memory card cannot be
used. Card may be damaged.
Insert another card.
(/k
(flashes)
• Use approved card.
• Format card. If problem persists, card may
be damaged. Contact Nikon-authorized
service representative.
• Error creating new folder. Delete files or
insert new memory card.
• Insert new memory card.
• Eye-Fi card is still emitting wireless signal
after Disable has been selected for Eye-Fi
upload. To terminate wireless transmission,
turn the camera off and remove the card.
Not available if Eye-Fi card is
locked.
(/k
(flashes)
Eye-Fi card is locked (write protected). Slide
card write-protect switch to “write” position.