Karcher HDS-C 7-11 Steel - Manual (Page 27)

- 11
German,Order.-Nr.: 5.391-558.0
English, Order no.: 5.391-559.0
French, Order no.: 5.391-560.0
Italian, Order no.: 5.391-561.0
Spanish, Order no.: 5.391-562.0
Portuguese, Order no.: 5.391-563.0
Dutch, Order no.: 5.391-564.0
Greek, Order no.: 5.391-565.0
Polish, Order no.: 5.391-566.0
Best.-Nr.: 6.414-278.0
Best.-Nr.:2.641-310.0
Best.-Nr.: 2.641-320.0
Best.-Nr.: 2.641-297.0
Best.-Nr.: 2.641-333.0
Order no. : 6.288-020.0
Order no. 6.288-050.0
Order no. : 6.288-072.0
Order no. : 6.288-116.0
Order no. : 6.290-911.0
For softening
ṇ
Warning!
Before using the cleaning agent, please re-
fer to the notice on the package. Do not use
the following cleaning agents:
– cleaning agent containing nitrit acid
– cleaning agent containing active chlo-
rinate
If you use such cleaning agents, it will dam-
age your equipment.
RM 100 ASF
RM 101 ASF
The warranty terms published by our com-
petent sales company are applicable in
each country. We will repair potential fail-
ures of your appliance within the warranty
period free of charge, provided that such
failure is caused by faulty material or de-
fects in fabrication. In the event of a warran-
ty claim please contact your dealer or the
nearest authorized Customer Service cent-
er. Please submit the proof of purchase.
Faults without display
Fault Possible cause Remedy By whom
Plant is not run-
ning Mains fuse have got triggered Check mains fuses and mains voltage Operator
No pressure
build-up in the
plant or pump is
knocking Amount of water supply is too low. Check water supply level (refer to technical data). Operator
Pipe is blocked Check all pipes to see that there are no blockages Operator
System is sucking air Check system for leaks, the detergent suction hoses
must lie in the detergent, refill detergent container. Operator
Only HDS-C 7/11, HDS-C 9/15: Heating
coil has heavy calcium deposits Softening using RM 110 is not working. Rectify
cause, decalcify the plant. Operator,
Customer
Service
Pump leaky
(more than 3
drops of water
per minute) Defective pump part Replace defective part. Customer
Service
Detergent is not
taken in Filter or hose is blocked Clean the parts. Operator
Backflow valve stuck Remove suction hose from pump head and loosen
the recoil valve using a blunt object. Operator
Solenoid valve is defective Replace valve. Customer
Service
High pressure
pump is sucking
in air. Detergent container is empty Refill detergent. Operator
Only HDS-C 7/
11, HDS-C 9/15:
Burner does not
ignite or the flame
glows off during
operation Washing programme with hot water not se-
lected. Select another washing programme. Operator
Water shortage Check water supply, check connections, clean water
shortage safeguard. Operator
Fuel filter dirty Change fuel filter. Operator
No ignition Check ignition. Customer
Service
Check ignition electrodes. Customer
Service
Too low water
temperature for
hot water opera-
tions Temperature has been set too low. Set the thermostat to a higher level. Operator
Nozzle in spray pipe is rinsed out. Define the quantity to be transported by the pump.
Replace nozzle if the specifications given in the tech-
nical data are exceeded with a large margin. Operator
Only HDS-C 7/11, HDS-C 9/15: Heating
coil has heavy calcium deposits Softening using RM 110 is not working. Rectify
cause, decalcify the plant. Customer
Service
Only HDS-C 7/11, HDS-C 9/15: Heating
coil sooted Remove the soot from the heating coil. Customer
Service
Accessories
Attachment sets
Sticker Operating Instructions
Water filter G 1"
Lance holder
Hose switch
Coin acceptor
Coin counter
Fuel
Engine oil Hypoid SAE 90
Engine oil 15W40
Silicon grease
Lock grease
Steel care product
Softener liquid RM 110
Detergent
RM 806 ASF, 1+3 Dosing ml/
min
HDS-C 9/15 120...150
HDS-C 7/11 98...120
HDS-C 8/15-E 110...135
Lime solvent
Warranty
27 EN