Karcher PC 60-130 T - Manual (Page 17)

- 7
ƽ
Danger
Risk of injury! The main switch is to be
switched off while carrying out any repairs
or maintenance jobs.
If malfunction can not be fixed, the de-
vice must be checked by customer serv-
ice.
Troubleshooting
Fault Possible cause Remedy of whom
Appliance is not running Main switch is switched off. Turn on the main switch. Operator
Mains fuse in the power supply is
faulty. Replace the fuse. Operator
Timer lapsed. Set the cleaning time. Operator
Device hood has not been closed
properly. Press the handle downward. Operator
Filling level too low. Fill water into the detergent container until
the indicator lamp "Heater" lights up green or
shuts off. Operator
There is no voltage in the machine. Check electrical mains. Electrician
The indicator lamp for the
heater will light up red Water shortage Fill water into the detergent container until
the indicator lamp "Heater" lights up green or
shuts off. Operator
Filling level sensor is faulty. Replace filling level sensor. Customer Service
The indicator lamp for the
operating status will light up
red Turntable overloaded. Take some load off the turntable or reposition
the parts. To reset a fault, briefly open the
machine hood and close it or briefly turn the
timer switch to "0". Operator
Turntable does not turn Load too heavy or too large. Remove some parts. Operator
Turntable loaded unevenly. Correct the load arrangement in the basket. Operator
Turntable defective. Check whether the turntable turns while it is
not loaded. If not, call customer service. Operator
Bad cleaning result Cleaning time too short. Increase the cleaning time. Operator
Detergent liquid is dirty. Replace the detergent liquid. Operator
Nozzles are blocked. Clean the nozzles. Operator
Filter blocked (optional). Clean or replace the filter inlay. Operator
Oil percentage in the detergent liquid
is too high. Turn on the skimmer. Operator
Pump does not work Check motor protection switch. Operator
Wrong rotating direction of the pump
motor. Rectify the electrical connection. The fan of
the pump motor must rotate in the direction of
the arrow. Electrician
Temperature too low. Set the thermostat to a higher level. Operator
Check thermostat or temperature limiter; re-
place, if required. Customer Service
The indicator lamp for tem-
perature will light up red Temperature limiter has got triggered. Allow the device to cool; remove the cause of
the fault. Reset the temperature limiter in the
heater switch cabinet by pressing the reset
button. Contact Customer Service if the fault
recurs.
Operator
17 EN