ADC CUDA 3 - Manual (Page 133)

Cuda 12000 IP Access Switch CLI-based Administration Guide
Packet Over SONET (POS) Interface Administration 131
Packet Scrambling
Enables scrambling of SONET Synchronous Payload Envelopes (SPEs) on this
interface. Note that both end-points of the transmission must use the same
scrambling. Scrambling is disabled by default.
To configure scrambling on a POS interface, perform the following task in
interface pos <c/s/i>
mode:
Note the following:
■
Only normal Path Remote Defect Indication is currently supported on
POS interfaces.
■
Only SONET signal (framing) is supported on POS interfaces. Configuring
and Viewing SONET Alarms
Task Command
Enable scrambling on the POS
interface. pos scramble