ADC CUDA 3 - Manual (Page 185)

Cuda 12000 IP Access Switch CLI-based Administration Guide
Configuring SNMP Event Notification Types 183
The following table lists the system events and their associated Event
Classes. For more information about Event Classes, refer to Chapter 10,
Managing System Events, on page 203.
Table 9-7 List of System Events
E
System Event Description Event Class
Cluster events: Cluster events refer to faults that affect
the management module.
■
authentication-failure SNMP receives a bad Community Name. Notice
■
bcm-failover-down Services are going down. This notification
type applies to redundant configurations
only. Notice
■
bcm-failover-up Services are coming up. This notification
type applies to redundant configurations
only. Notice
■
bcm-state-change A change in the craft port IP address. Notice
■
bcm-sw-mismatch The secondary will not come up because
its software revision does not match the
software revision of the primary. Notice
■
trace-log For ADC internal use only. Notice
■
cold-start Generated when module boots from
power up. Notice
■
warm-start Generated when module boots from reset. Notice
■
icl-state-change A change in the ICL link. Notice
Module events: Module events refer to hardware faults
that affect any application module.
■
cable-modem-auth-failure Cable modem failed authorization and did
not register. Notice
■
cable-modem-down Cable modem is not operational. Critical
■
cable-modem-up Cable modem is operational. Notice
■
card-down Application module failure. Critical
■
card-up Application module is operational. Notice
■
dhcp-relay-not-configured DHCP configuration error. Warning
■
local-sonet-alarm A transmission problem is detected from
the transmitter. Error
■
remote-sonet-alarm A transmission problem is detected from
the receiver. Error